Office – Page 46 – Cal Lab Magazine

Additel Thermocouple Calibration Furnaces

May 19, 2020 Office

Brea, Calif., May 19, 2020 – Additel Corporation introduces their new ADT875-1210 and ADT878-1210 Thermocouple Calibration Furnaces which cover a temperature range of 100°C to 1210°C. Each unit comes standard with Additel’s patented tri-zone “Adaptive […]

Rohde & Schwarz 1.35 mm E-band Coaxial Connector

May 18, 2020 Office

By adding the R&S NRP90T und R&S NRP90TN models to its portfolio of thermal power sensors, Rohde & Schwarz releases the very first test and measurement instruments in the market to support the novel, robust 1.35 […]

NIM Newsletter Launched | National Institute of Metrology of China | NIM

May 10, 2020 Office

The first issue of NIM Newsletter is now available online. It is a new way of sharing updates on NIM’s research and operation with friends around the world. This Issue comes at a special time […]

Reliable measurement of magnetic fields on the nanometer scale – PTB.de

May 7, 2020 Office

PTB-News 2.2020 So far, no internationally standardized measurement procedures have been available to measure magnetic field distributions that vary spatially on the nanometer scale. The NanoMag EMPIR metrology research project, which was spearheaded by PTB […]

New instrument for comparing primary standards of pure β-emitting radionuclides – BIPM News

April 30, 2020 Office

The accurate measurement of radioactivity is essential for applications of ionizing radiation such as medical imaging, cancer therapy and environmental protection. To ensure that such measurements are harmonized world-wide, the BIPM operates a set of […]

Choosing the Proper Measurement Tool

April 30, 2020 Office

by Joseph P. Fuehne, Ph.D., P.E. The Purdue Polytechnic Institute in Columbus utilizes metrology tools with targeted measurement artifacts, which may be 3-D printed or machined, to facilitate learning and provide opportunities to demonstrate competency […]

Converting a mV/V Load Cell Signal into Engineering Units

April 30, 2020 Office

by Henry Zumbrun One might read the headline and think why is mV/V or a calibration curve relevant to me or my instrumentation? If you use load cells or other instrumentation that are calibrated using […]

Fundamentals of Electrical Safety Testing – Pt. 2

April 27, 2020 Office

Introduction Part 1 of this white paper discussed the functions and features of these high-performance instruments. The purpose of this section is to guide the hipot tester user through the steps needed to make sure […]